top of page

acMiterSurface

Creates the miter surface between two surfaces. 

icon_MiterSurface_256x256.png

Commandline Options

ExtendSurface

yes /no
wether or not to extend the input surface in all directions by value ExtensionLength

ExtensionLength

number
the length to extend the input surface in all directions

ExtrusionWidth

number
the width of the newly created surface

NumberOfDivisions

number
defines the fineness of the result along the interesction of the two input surfaces. for planar surfaces this can be set to 1, the more curved the inputs are the higher this number should be.

FlipSurface

on /off
flips the miter side between the two input surfaces

bottom of page